Center Line Radius (CLR) and Arc Length or.When specifying roll bending, the following information is required: Square and rectangular tubing sizes: 3/4″ through 3″ – Easy Way or Hard Way – see Rotary Bending.Here are the specs for our roll bending capabilities: When possible all the radii bends are combined and rolled as one larger length then split after rolling, if desired. The arc length is limited by the stock length of material less the minimum tangent lengths. ![]() ![]() Minimum tangent lengths required are 8″ each end up through 2″ pipe size (2.38 O.D.) and 18″ each end for material larger than 2″ pipe. Roll BendingWe provide capabilities that include small diameter pipe and tube bending, and arc bending greater than 180 degrees.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |